Wet Chasm

Publisher: Fat Dragon GamesChasms are great, but how about spicing up a cavern map with an underground river or lake?  This set of 3D-printable STL models combines the Chasm walls with water bases, to provide chasms with a watery bottom.  It includes an entrance and two varieties of water spray, along with multiple chasm walls and corners.
As before, the chasm models in this set stick up far enough to make a smooth edge with an upper level of tiles (see the sample rendering on the cover image).  You can either rest the upper level on a lower level of tiles, or use the Dragonbite Tiles Risers to support the upper level.  All the pieces in this set should be clipped in place from the bottom.
Important: This set includes smooth water sections, in the style of the current FDG Cavern Expansion 1 pieces.  See the Wavy Chasm set for the same pieces with rippled water sections in the style of the legacy FDG Cavern Expansion 1 pieces.

Recommended Print Settings:

Layer Size: 0.15mm, or 0.1mm for finer detail

Infill: 10% for all models recommended, 5% minimum

Top/Bottom Layers: 6 (or 0.9mm)

Side Shell Count: 2 (or 0.8mm)

Raft/Brim/Supports: none

Related Sets:

Chasm — these same chasm walls on dry cavern floors

Crossing the Chasm — natural rock steps across a chasm, on both wet and dry floors

Wavy Chasm — these same pieces but with rippled water in the style of the legacy FDG cavern water pieces
FDG Cavern Starter Set — dry cavern floors
FDG Cavern Expansion 1 — cavern full-water floors, with and without rocks/stones

Price: $10.99
Go to Source